Executing your Program

When the loader pms91 is finished, then you must place the $\mu$Stamp11 back in RUN mode. This is done by sliding SW2 to RUN and SW1 to PROT position. After doing this, you open the Hyperterm window and connect to the $\mu$Stamp11. Your Hyperterm shell should be communicating through your laptop's serial port (COM1) at 38K baud with 8 data bits and 1 stop bit. You then hit the RESET button and your program should start executing. The Hyperterm window should first type out Hello World, followed by the phase Goodbye CRUEL World at each blink of the LED.